+- Jellyfin Forum (https://forum.jellyfin.org)
+-- Forum: Support (https://forum.jellyfin.org/f-support)
+--- Forum: Troubleshooting (https://forum.jellyfin.org/f-troubleshooting)
+---- Forum: Networking & Access (https://forum.jellyfin.org/f-networking-access)
+---- Thread: Tailscale remote access (/t-tailscale-remote-access)
Tailscale remote access - mihairaul - 2025-01-23
Hello,
I looked everywhere and tried everything, therefore I am here asking for your help
So, I can access my TrueNAS scale server by using the 100.x.x.x IP address that Tailscale provided for it, but I cannot acces my Jellyfin app remotely. For some reason, {removed-by-mod} also isn’t working, so I’m assuming I did something wrong.
On the JF side: checked enable remote connections, entered a ton of LAN addresses (100.x.x.x type), tried checking unchecking port mapping auto. With every setting, I restarted JF.
On TS side: everything seems to be working correctly, I can see all the machines there. I had to check “Host Network” at installing; without this option, I couldn’t see the server via 100.x.x.x address.
Any thoughts?
Sincerely,
Mihai
RE: Tailscale remote access - jimmyjammy - 2025-01-23
These are my Jellyfin Server settings with Tailscale & it allows me remote access. Check the allow remote connections box, under "Remote IP address filter" add this 100.64.0.0/10 (It's the ip's that tailscale uses. Set "Remote IP address filter mode" to "whitelist" & make sure that "Enable automatic port mapping" is unchecked (not selected). Click the blue "save" button at the bottom & restart the server.
Hope that this works for you!
JJ
RE: Tailscale remote access - mihairaul - 2025-01-29
Thanks for your reply!
I didn’t change anything and it begun to run.
The only thing is now that I access the servers (jellyfin and file share) through the local area IP address (192.168.x.x).
Is this a bad thing?
Mihai