Jellyfin Forum
SOLVED: No shows after update - Printable Version

+- Jellyfin Forum (https://forum.jellyfin.org)
+-- Forum: Support (https://forum.jellyfin.org/f-support)
+--- Forum: Troubleshooting (https://forum.jellyfin.org/f-troubleshooting)
+---- Forum: Media Scanning & Identification (https://forum.jellyfin.org/f-media-scanning-identification)
+---- Thread: SOLVED: No shows after update (/t-solved-no-shows-after-update)



No shows after update - Seventh8096 - 2024-07-26

I just updated my Synology/docker server to v10.9.8. I did a clean install and added my movies and shows libraries. Movies were all picked up right away. Shows do not pick up any of my shows. I've tried deleting the library and readding multiple times. My movies and shows live in the same Media folder with the same permissions. Any ideas?

   


RE: No shows after update - TheDreadPirate - 2024-07-26

Can you share your jellyfin log via pastebin?


RE: No shows after update - Seventh8096 - 2024-08-06

(2024-07-26, 04:54 PM)TheDreadPirate Wrote: Can you share your jellyfin log via pastebin?

My apologies, I didn't get a notification and just saw this reply. Below is my Jellyfin log. Thank you for your help.

https://pastebin.com/xH1y9FGG


RE: No shows after update - TheDreadPirate - 2024-08-06

Set this docker environment variable to 0.

DOTNET_SYSTEM_GLOBALIZATION_INVARIANT


RE: No shows after update - Seventh8096 - 2024-08-06

That fixed it, thank you so much!


RE: No shows after update - Kevinvl96 - 2024-08-07

(2024-08-06, 03:04 PM)TheDreadPirate Wrote: Set this docker environment variable to 0.

DOTNET_SYSTEM_GLOBALIZATION_INVARIANT

I used this aswell in my setup to get it to work, thanks! One question though, is this a setting I can leave at 0 or do I need to change it back to 1 at some point.


RE: No shows after update - TheDreadPirate - 2024-08-07

Leave it at 0.


RE: No shows after update - Efficient_Good_5784 - 2024-08-07

(2024-08-07, 06:53 PM)Kevinvl96 Wrote:
(2024-08-06, 03:04 PM)TheDreadPirate Wrote: Set this docker environment variable to 0.

DOTNET_SYSTEM_GLOBALIZATION_INVARIANT

I used this aswell in my setup to get it to work, thanks! One question though, is this a setting I can leave at 0 or do I need to change it back to 1 at some point.
You shouldn't need to as it's no longer valid with v10.9.#