QSV stopped worked after update - Printable Version +- Jellyfin Forum (https://forum.jellyfin.org) +-- Forum: Support (https://forum.jellyfin.org/f-support) +--- Forum: Troubleshooting (https://forum.jellyfin.org/f-troubleshooting) +--- Thread: QSV stopped worked after update (/t-qsv-stopped-worked-after-update)

QSV stopped worked after update - sunshine_reggae - 2024-08-06 I updated jellyfin from 10.9.0 to 10.9.7 on my xpenology (synocommunity repository) and after that any try to transcoding ends with "Playback error Playback failed due to a fatal player error". Transcoding setting the same.  I use Intel pentium G4400 (skylake) Before update I used ffmpeg (w/o any numbers, from synocommunity too), after update it requires ffmpeg 6, I installed it and gave it all rights (r/w) to all media libraries  log 1 log 2 log 3 RE: QSV stopped worked after update - Fate - 2024-08-06 Please post jellyfin and ffmpeg transcoding logs via pastebin.( ah you posted logs already let me check) Do you have any Intel driver loaded? It could be G4400 is not supported via QSV anymore... Try to change to vaapi just for testing. RE: QSV stopped worked after update - 34626 - 2024-08-06 If it's a community based version of Jellyfin, you should write about this on their forum, can you downgrade, if, does it then work again? RE: QSV stopped worked after update - nyanmisaka - 2024-08-06 This is a community built version of ffmpeg, although it uses our patches, the Intel libs shipped with it may be missing. Skylake requires the MediaSDK runtime instead of VPL.