Today, 03:25 AM
Running jellyfin on Windows 10
Earlier this year I built a new NAS and migrated the data over to it.
What was the X: drive is now V:
I went library by library, added the V: path then removed the X: path.
It worked fine for a while. However since updating to the latest 10.11 all my shows have duplicated.
Even though when I edit a Library only the V: path is shown.
Tonight I removed a channel to redo it and BOTH paths show up in the "Remove Medi Folder" popup
I click OK. Then I shut down jellyfin and restarted it.
When I added the path back in as a new library the error popup happened:
"The library is in an invalid state and cannot be edited. You are possible encountering a bug: the path in the database is not the correct path in the system"
Any help would be very appreciated!
Both libraries were named the same if that helps?
Earlier this year I built a new NAS and migrated the data over to it.
What was the X: drive is now V:
I went library by library, added the V: path then removed the X: path.
It worked fine for a while. However since updating to the latest 10.11 all my shows have duplicated.
Even though when I edit a Library only the V: path is shown.
Tonight I removed a channel to redo it and BOTH paths show up in the "Remove Medi Folder" popup
I click OK. Then I shut down jellyfin and restarted it.
When I added the path back in as a new library the error popup happened:
"The library is in an invalid state and cannot be edited. You are possible encountering a bug: the path in the database is not the correct path in the system"
Any help would be very appreciated!
Both libraries were named the same if that helps?