2024-01-29, 09:09 PM
(This post was last modified: 2024-01-29, 09:13 PM by Efficient_Good_5784. Edited 1 time in total.)
You can post the logs here for others to read and make sense of. Just make sure to comment out external IPs and sensitive paths/filenames.
You're only accessing your server through Tailscale? Are you not present in the physical location of your server? Or are you using Tailscale while being right next to the server?
Going off of my experience using Tailscale with Jellyfin (both installed on a Truenas Scale server), it takes a while for episodes to load into the player (with good connections on both sides no less).
It sounds like HWA is working for you. You stated that your CPU load increases with HWA off. With HWA being on, if it doesn't work, your streams would fail to even play.
Also make sure that you're using those commands to check for HWA ability through the container's shell. If you're doing so on Truenas's shell, that's not what the container might see. You have to open up the shell for the container itself, then run that command to see what the container sees.
You're only accessing your server through Tailscale? Are you not present in the physical location of your server? Or are you using Tailscale while being right next to the server?
Going off of my experience using Tailscale with Jellyfin (both installed on a Truenas Scale server), it takes a while for episodes to load into the player (with good connections on both sides no less).
It sounds like HWA is working for you. You stated that your CPU load increases with HWA off. With HWA being on, if it doesn't work, your streams would fail to even play.
Also make sure that you're using those commands to check for HWA ability through the container's shell. If you're doing so on Truenas's shell, that's not what the container might see. You have to open up the shell for the container itself, then run that command to see what the container sees.