2024-02-02, 01:42 AM
Thanks for this guide - one thing I don't see mentioned is whether we should change that ip address under the JELLYFIN_PublishedServerUrl variable to something specific to our setup or if we're supposed to use our main gateway IP like shown. I have been trying to tackle the issue of "slow HTTP response" littering my logs and have seen quite a few solutions out there indicating to change this variable but they all word it slightly differently and of course their own examples don't help me.
Some say "your container's local IP" so like the IP found when you open the container's detail view and look under "network" in the "general" tab?
Some say "the IP address of your server, without a port."
Some say "the name of the domain you're using."
The official compose doc's comments say "alternative address used for autodiscovery."
I am very confused about what to use, if anything here. And whether I should just wait for this thing to grind through my library before I make any judgements about speed. I started to get poke around when it was going on like 48 hours to process my music library, and every screen takes forever to load, but maybe that's normal behavior while doing an initial scan. Plex says I have around 5000 or so albums in total, does that seem like a reasonable timeframe to process that data?
Sorry if this is a hijack of this thread's intended purpose.
Some say "your container's local IP" so like the IP found when you open the container's detail view and look under "network" in the "general" tab?
Some say "the IP address of your server, without a port."
Some say "the name of the domain you're using."
The official compose doc's comments say "alternative address used for autodiscovery."
I am very confused about what to use, if anything here. And whether I should just wait for this thing to grind through my library before I make any judgements about speed. I started to get poke around when it was going on like 48 hours to process my music library, and every screen takes forever to load, but maybe that's normal behavior while doing an initial scan. Plex says I have around 5000 or so albums in total, does that seem like a reasonable timeframe to process that data?
Sorry if this is a hijack of this thread's intended purpose.