2024-08-20, 10:12 PM
(This post was last modified: 2024-08-20, 10:20 PM by randomeyes227. Edited 1 time in total.)
Background info - New forum member here and I just switched away from Emby for the past 5(iirc) yrs. When using Emby, I hosted it on my NAS (Synology DS418play, no containers, 2GHz Celeron proc, 6GB ram). Occasionally I would have an issue if there were too many re-encoding sessions happening. I decided to change to Jellyfin but apparently it needs to run in a Docker container. Docker isn’t supported on my NAS but it can be side-loaded. Since the NAS is rather weak in the processor dept, I decided to use my desktop (i7-3770 3.4GHz 4core, 16GB ram) to host Jellyfin as well. I host all of my media on the NAS shares (~12tb of space). I noticed that when my roku sticks would try to watch a mkv movie, it would have to recode and the CPU on my desktop would run at 100%. At this point, I looked into Handbrake and to recode my movie collection to h264 (mp4). With that encoding, Jellyfin can direct play without issue.
Tldr – Had Emby, Now Jellyfin, new config might warrant an upgrade.
I’m trying to use Handbrake to recode some of my media and it seems like a movie typically take about 1.5hr to recode. I’ve had this computer (HP 6300 SFF) for about 5yrs now and even then, I bought it from surplus. If I’m going to upgrade my desktop, what would be something I should consider? I’m not a “gamer” and while I suppose I could, I can’t justify spending 5k on a desktop to essentially only host Jellyfin, run Handbrake to transcode a movie in 15min (is that even realistic?), and just surf the internet? Any recommendations on models or even CPUs to look for? I’m sure there’s a lot of variables that could come into the equation. Ranging from what you’re encoding to the HW you’re using. I searched for hardware discussions but couldn’t find anything that covered the HW and what to expect for times.
Any thoughts or advice?
Tldr – Had Emby, Now Jellyfin, new config might warrant an upgrade.
I’m trying to use Handbrake to recode some of my media and it seems like a movie typically take about 1.5hr to recode. I’ve had this computer (HP 6300 SFF) for about 5yrs now and even then, I bought it from surplus. If I’m going to upgrade my desktop, what would be something I should consider? I’m not a “gamer” and while I suppose I could, I can’t justify spending 5k on a desktop to essentially only host Jellyfin, run Handbrake to transcode a movie in 15min (is that even realistic?), and just surf the internet? Any recommendations on models or even CPUs to look for? I’m sure there’s a lot of variables that could come into the equation. Ranging from what you’re encoding to the HW you’re using. I searched for hardware discussions but couldn’t find anything that covered the HW and what to expect for times.
Any thoughts or advice?