2024-10-13, 05:39 PM
(2024-10-13, 03:44 PM)TheDreadPirate Wrote: Did you setup low power encoding?
https://jellyfin.org/docs/general/admini...e-on-linux
Also, since you're using a backport kernel, did you also install all the kernel header, module, and firmware packages?
I have not setup low power encoding, because I thought it wasn't needed.
I used to run it without the dGPU, but still didn't run it with low power encoding. since the 12600 isn't a low power chip I believe.
What does using a backport kernel mean?
I'm sorry, I'm a bit unfamiliar with the kernel headers, module, and firmware packages.
Did I have an oversight in the installation of my software?
I ran the
apt update && apt upgrade commands.Again, sorry, I think this is a little above my knowledge level at the moment. 😅
Thank you very much for taking the time to help!