Populating media files

[VulcanRidr]

The host is resolving IPv6 addresses for TMDB.

Code:

15:41:02.312512 [0-0] == Info: IPv6: 2400:52e0:1a00::1067:1

You have IPv6 enabled to some degree.  At least from your DNS provider.  I'm not familiar with the differences between jails and docker container/LXC's.  But in Docker/LXCs, I've seen similar situations as this where Jellyfin's container is not setup for IPv6, or Jellyfin itself is not configured to allow IPv6.

Okay, First of all, and I am not sure how long you have been doing linux...But if you remember OpenVZ or maybe linux-vserver, they were both based on FreeBSD jails.

In any case, I have gone in and (hopefully) killed ipv6 in the interface. I added

Code:

plugin query "filter-aaaa.so" {
           filter-aaaa-on-v4 yes;
           };

in my named.conf files and restarted bind9...So in theory, it should not be receiving AAAA, and then I restarted the jail and jellyfin. However, I am still getting the same behavior from the interface, in that I will get one mnew movie added to the interface, and I have to start it, and (usually) then I reload the UI, and maybe will get another move. Right now, I have a total of 25 movies out of just north of 350. And my Shows, I have one episode, and when I click on it, I get

Code:

Playback Error
Unable to find a valid media source to play.

For some users they either enabled IPv6 in Jellyfin, if their host interface had an IPv6 address, or took additional steps to prevent IPv6 DNS resolution.

Hopefully this is fixed. Should at least the existing movies start getting posters instead of random screenshots of from the movies?