2024-12-17, 03:43 AM
(2024-12-07, 04:03 AM)finicky6457 Wrote: Comcut works well for me. Here is the version of a post processing script I use:
https://github.com/redaters/Jellyfin-Pos...eencode.sh
@finicky6457 would you mind expanding on how to set this up? It appears you may be running Jellyfin in a docker container (based on where you are calling /usr/lib/jellyfin-ffmpeg/ffmpeg . Are you running a docker compose to setup comcut ? I am just beginning my research, but from what I've seen, many of the solutions are not necessarily tailored to use in a docker container. For example, the Jellyfin recommendation to run a post-processing script requires a python3 executable as a dependency. Not sure that is possible in a container without a lot more config. In any event, if you could further describe the steps to get your solution running, that would be great.