Flash Intel Arc GPU Firmware in Linux

[boekhold]

If there is no OPROM available for your card, then it hasn't received an update since the card was released, and it is ok to skip that portion.

This was the case for the user above with their Asrock low profile A380.

I have this ASRock Low Profile A380, and I cannot find a specific OPROM *or* a FW file. Is it OK to just update:

- dg2_c_oprom.rom
- dg2_gfx_fwupdate_SOC2.bin

Based on the below, I believe that the most I can apply is the "dg2_gfx_fwupdate_SOC2.bin" firmware? There doesn't seem to be any oprom-data, oprom-code or fw-data available that matches my card (1849:6006)?

Code:

boekhold > cytro > ~/arc $ sudo ./igsc list-devices
Device [1] '/dev/mei1': 8086:56a5 1849:6006 0000:09:00.00

boekhold > cytro > ~/arc $ sudo ./igsc oprom-data supported-devices --image dg2_d_asrock_challenger-a380_oprom-data.rom
OPROM Data supported devices:
Vendor Id: 8086 Device Id: 56A5 SubSystem Vendor Id: 1849 SubSystem Device Id: 6004

boekhold > cytro > ~/arc $ sudo ./igsc oprom-code supported-devices --image dg2_c_oprom.rom
OPROM Code image does not have the supported devices extension

boekhold > cytro > ~/arc $ sudo ./igsc fw-data supported-devices --image fwdata/dg2_asrock_challenger-a380_config-data.bin
firmware data supported devices:
Vendor Id: 8086 Device Id: 56A5
Subsys Vendor Id: 1849 Subsys Device Id: 6004

The reason I'm keen to update "something" is because (nothing Jellyfin related btw) when connected with an HDMI cable to my 21:9 4K monitor, the card does not correctly detect the display, and won't go into a higher resolution than 1920x1080. If I use a DisplayPort cable, the card correctly detects the display and goes into full resolution. Unfortunately I already have another PC connected to this monitor via DisplayPort and I don't have another DP port free. I'm hoping a firmware update will fix this.