2025-02-08, 02:09 PM
Thank you for your response.
I had added "net.ipv6.conf.all.use_tempaddr = 0" to sysctl.conf yesterday before making this post but I have to wait until about 6pm for the IP to change to see if it made a difference, the IP still changed unfortunately.
I would imagine that should encompass my specific adapter as well, but I have now removed that line and put in "net.ipv6.conf.enp1s0.use_tempaddr = 0" and will see if that works tomorrow.
I was just looking at this page https://jellyfin.org/docs/general/networking/ and was reading the section about reverse proxies. Should I have something in the "Known Proxies" section? I've basically done nothing in the network settings of Jellyfin except disable ipv4 and enable ipv6, everything else on that page is just blank or whatever the default settings are.
I had added "net.ipv6.conf.all.use_tempaddr = 0" to sysctl.conf yesterday before making this post but I have to wait until about 6pm for the IP to change to see if it made a difference, the IP still changed unfortunately.
I would imagine that should encompass my specific adapter as well, but I have now removed that line and put in "net.ipv6.conf.enp1s0.use_tempaddr = 0" and will see if that works tomorrow.
I was just looking at this page https://jellyfin.org/docs/general/networking/ and was reading the section about reverse proxies. Should I have something in the "Known Proxies" section? I've basically done nothing in the network settings of Jellyfin except disable ipv4 and enable ipv6, everything else on that page is just blank or whatever the default settings are.