2025-04-03, 02:32 PM
(This post was last modified: 2025-04-03, 02:42 PM by dwjelly. Edited 3 times in total.)
I just installed a new Intel A310 into my XCP-ng host server, where I am running a Jellyfin VM. The VM is running Ubuntu 24.4. I followed the instructions on the Jellyfin website for setting up transcoding. Everything went well except when I ran this command...
sudo /usr/lib/jellyfin-ffmpeg/ffmpeg -v verbose -init_hw_device vaapi=va
dev/dri/renderD128 -init_hw_device opencl@va
I am getting the following error...
If anyone has suggestions, I would appreciate the help. Thanks.
Just so you know, in the posted cmd above, it should be a forward slash and a colon, not a confused face. Will not let me add without changing to a face.
sudo /usr/lib/jellyfin-ffmpeg/ffmpeg -v verbose -init_hw_device vaapi=va
dev/dri/renderD128 -init_hw_device opencl@vaI am getting the following error...
Trying to figure out how to run and use OpenCL. It installed correctly, but when I run clinfo --list, coming up empty
If anyone has suggestions, I would appreciate the help. Thanks.
Just so you know, in the posted cmd above, it should be a forward slash and a colon, not a confused face. Will not let me add without changing to a face.