Yesterday, 09:56 PM
(This post was last modified: 11 hours ago by matt1984. Edited 1 time in total.)
I updated (Windows install) all seemed to be going ok but the jellyfin process closed. Reloaded and it loaded into 10.11 then went to do the full scan as advised but within a few mins the main jellyfin process closed again. Again relaunched it from the tray app and once again within a few mins it goes again. Can’t see anything in the log, the last few lines are just:
22:43:43.401 +01:00] [WRN] [34] MediaBrowser.Controller.Entities.BaseItem: Library folder "C:\ProgramData\Jellyfin\Server\data\playlists" is inaccessible or empty, skipping
[2025-10-20 22:44:04.854 +01:00] [WRN] [31] Emby.Server.Implementations.HttpServer.WebSocketConnection: WS "192.168.50.1" error receiving data: "The remote party closed the WebSocket connection without completing the close handshake."
[2025-10-20 22:44:04.868 +01:00] [INF] [31] Emby.Server.Implementations.HttpServer.WebSocketManager: WS "192.168.50.1" closed
can’t see what’s wrong, all I can think is the initial time the process closed it hadn’t actually properly finished?
To go back to 10.10.7 would it just be a case of uninstalling then reinstalling the older one and popping my backup of data and config back? I’ve never had to roll back before as it’s always been so smooth
Edited to add: back on 10.10.7 now and so far seems as stable as was before. Such a shame as 10.11 seemed much faster, but just wouldn’t stay running
- I’ll give it another go probably when a .1 is out
22:43:43.401 +01:00] [WRN] [34] MediaBrowser.Controller.Entities.BaseItem: Library folder "C:\ProgramData\Jellyfin\Server\data\playlists" is inaccessible or empty, skipping
[2025-10-20 22:44:04.854 +01:00] [WRN] [31] Emby.Server.Implementations.HttpServer.WebSocketConnection: WS "192.168.50.1" error receiving data: "The remote party closed the WebSocket connection without completing the close handshake."
[2025-10-20 22:44:04.868 +01:00] [INF] [31] Emby.Server.Implementations.HttpServer.WebSocketManager: WS "192.168.50.1" closed
can’t see what’s wrong, all I can think is the initial time the process closed it hadn’t actually properly finished?
To go back to 10.10.7 would it just be a case of uninstalling then reinstalling the older one and popping my backup of data and config back? I’ve never had to roll back before as it’s always been so smooth
Edited to add: back on 10.10.7 now and so far seems as stable as was before. Such a shame as 10.11 seemed much faster, but just wouldn’t stay running
- I’ll give it another go probably when a .1 is out