2024-04-18, 12:13 AM
You need to have the new folder in your library, even if it is currently empty, ahead of time if you want a clean cut over. But if this is for a whole you will have to think ahead a little.
You will have create the folder you are going to mount the hard drive to NOW and add it to your docker config, then add this folder to your library.
Stop Jellyfin, change where the hard drive is mounted, start Jellyfin. It SHOULD cut over cleanly and rescan everything but preserve metadata and watch status.
You can always backup /config just in case.
You will have create the folder you are going to mount the hard drive to NOW and add it to your docker config, then add this folder to your library.
Stop Jellyfin, change where the hard drive is mounted, start Jellyfin. It SHOULD cut over cleanly and rescan everything but preserve metadata and watch status.
You can always backup /config just in case.
Jellyfin 10.9.2
Ubuntu 24.04 LTS (bare metal)
Intel i3 12100 on Asus Prime H610M-E D4 mATX
32GB DDR4-3600
Intel Arc A380
OS drive - SK Hynix P41 1TB
Storage
WD Green 3TB (Samba shares)
WD Red 3TB CMR (WIP Media, Test libraries)
3x WD Red Pro 6TB CMR in RAIDZ1 (JF Library)
Fractal Meshify 2
Corsair CX430
Ubuntu 24.04 LTS (bare metal)
Intel i3 12100 on Asus Prime H610M-E D4 mATX
32GB DDR4-3600
Intel Arc A380
OS drive - SK Hynix P41 1TB
Storage
WD Green 3TB (Samba shares)
WD Red 3TB CMR (WIP Media, Test libraries)
3x WD Red Pro 6TB CMR in RAIDZ1 (JF Library)
Fractal Meshify 2
Corsair CX430