2024-03-27, 07:43 PM
(This post was last modified: 2024-03-27, 07:43 PM by TheDreadPirate.)
Did you pass in the render group into the container? If this container is running at root, than this doesn't matter.
Only VAAPI allows you to specify a render device to use. The other vendor specific options rely on the driver to properly detect and use the appropriate device.
What happens when you select Quick Sync? Can you share the ffmpeg log when HWA is set to Quick Sync? Also, did you check both Low Power Encoding options? If so, I believe you still need to install the HuC and GuC firmware.
https://jellyfin.org/docs/general/admini...e-on-linux
Alternatively, you could UNcheck them since they aren't necessary for the N100.
Code:
group_add:
- "122" # Change this to match your "render" host group id and remove this comment
Only VAAPI allows you to specify a render device to use. The other vendor specific options rely on the driver to properly detect and use the appropriate device.
What happens when you select Quick Sync? Can you share the ffmpeg log when HWA is set to Quick Sync? Also, did you check both Low Power Encoding options? If so, I believe you still need to install the HuC and GuC firmware.
https://jellyfin.org/docs/general/admini...e-on-linux
Alternatively, you could UNcheck them since they aren't necessary for the N100.
Jellyfin 10.9.2
Ubuntu 24.04 LTS (bare metal)
Intel i3 12100 on Asus Prime H610M-E D4 mATX
32GB DDR4-3600
Intel Arc A380
OS drive - SK Hynix P41 1TB
Storage
WD Green 3TB (Samba shares)
WD Red 3TB CMR (WIP Media, Test libraries)
3x WD Red Pro 6TB CMR in RAIDZ1 (JF Library)
Fractal Meshify 2
Corsair CX430
Ubuntu 24.04 LTS (bare metal)
Intel i3 12100 on Asus Prime H610M-E D4 mATX
32GB DDR4-3600
Intel Arc A380
OS drive - SK Hynix P41 1TB
Storage
WD Green 3TB (Samba shares)
WD Red 3TB CMR (WIP Media, Test libraries)
3x WD Red Pro 6TB CMR in RAIDZ1 (JF Library)
Fractal Meshify 2
Corsair CX430