2025-09-26, 08:57 AM
(This post was last modified: 2025-09-26, 09:10 AM by puzzl. Edited 2 times in total.)
Hello,
I’m experiencing a problem with transcoding using an RTX 5060 (rebar , above 4g enabled).
Setup:
The GPU is passed to the container with --gpus=all, and NVENC hardware acceleration is enabled. Everything works fine when transcoding normally. However, whenever I skip forward (e.g., to the middle of a movie), the playback freezes: Jellyfin takes about 10–15 seconds “thinking,” then pauses the stream. After that, nothing happens, even if I press play again.
Could you please help me figure out what’s wrong?
If logs or any additional information are needed, I’ll be happy to provide them. I was hoping this setup would be the ultimate solution for me, but right now I feel a bit disappointed—either due to my own misconfiguration or some limitation with NVENC.
I’d really appreciate your help.
Thank you in advance!
I’m experiencing a problem with transcoding using an RTX 5060 (rebar , above 4g enabled).
Setup:
- nvidia-drivers-580-server-open
- nvidia-toolkit
- jellyfin docker 10.10.7
The GPU is passed to the container with --gpus=all, and NVENC hardware acceleration is enabled. Everything works fine when transcoding normally. However, whenever I skip forward (e.g., to the middle of a movie), the playback freezes: Jellyfin takes about 10–15 seconds “thinking,” then pauses the stream. After that, nothing happens, even if I press play again.
Could you please help me figure out what’s wrong?
If logs or any additional information are needed, I’ll be happy to provide them. I was hoping this setup would be the ultimate solution for me, but right now I feel a bit disappointed—either due to my own misconfiguration or some limitation with NVENC.
I’d really appreciate your help.
Thank you in advance!
