2024-06-18, 04:51 PM
(This post was last modified: 2024-06-18, 04:56 PM by pol77. Edited 1 time in total.)
Hello TheDreadPirate...
My journey into the rabithole continues but I think I have dived deeper than my current abilities.
I am successfulyl running the Jellyfin container server on my QNAP TS-873A and I have mapped the required folders on my Shared drive, so I can backup and restore the configuration successfully, thanks to your pointers and some research.
I quickly found out that I need a GPU to transcode if I am to have any actual use for the Jellyfin server and installed a Quadro P1000 which has been recognized, drivers installed and set to Container mode so it can be used by the QNAP container station.
After this point, I have found many conflicting guides and linux commands that do not seem to correspond to my situation.
Is it possible to configure my existing container to use the GPU or do I need to make a fresh installation? If I need a fresh installation, what do I need to add / do differently in order for it to use the GPU.
Many thanks!
My journey into the rabithole continues but I think I have dived deeper than my current abilities.
I am successfulyl running the Jellyfin container server on my QNAP TS-873A and I have mapped the required folders on my Shared drive, so I can backup and restore the configuration successfully, thanks to your pointers and some research.
I quickly found out that I need a GPU to transcode if I am to have any actual use for the Jellyfin server and installed a Quadro P1000 which has been recognized, drivers installed and set to Container mode so it can be used by the QNAP container station.
After this point, I have found many conflicting guides and linux commands that do not seem to correspond to my situation.
Is it possible to configure my existing container to use the GPU or do I need to make a fresh installation? If I need a fresh installation, what do I need to add / do differently in order for it to use the GPU.
Many thanks!