2025-01-05, 07:32 PM
I installed the SynoCommunity version on my DS420+ a while ago and it didn´t do well due to RAM issues.
After upgrading the RAM I would like to give it another try.
The NAS is recognized, but instead of the startup wizard I just get a login.
The old user/password combination is not valid with this install.
I uninstalled again and SSH-ed into /volume1/@appdata/jellyfin , because I thought there might be leftovers from the previous install, but it was empty.
Are there other places credentials are stored?
Right now I´m running jellyfin on my Windows PC. Might this cause problems?
I did shut the windows version down, before starting up the Syno-version.
The local IP of the NAS changed since the first install.
The old NAS was shown to me first , but it did find the new one.
I run DSM 7.2.2.
Thanks for your help
After upgrading the RAM I would like to give it another try.
The NAS is recognized, but instead of the startup wizard I just get a login.
The old user/password combination is not valid with this install.
I uninstalled again and SSH-ed into /volume1/@appdata/jellyfin , because I thought there might be leftovers from the previous install, but it was empty.
Are there other places credentials are stored?
Right now I´m running jellyfin on my Windows PC. Might this cause problems?
I did shut the windows version down, before starting up the Syno-version.
The local IP of the NAS changed since the first install.
The old NAS was shown to me first , but it did find the new one.
I run DSM 7.2.2.
Thanks for your help