2025-09-24, 11:40 PM
(This post was last modified: 2025-09-27, 10:00 PM by jellykrabbypatty. Edited 1 time in total.)
I spent the entire day trying to do this and followed the video to a Tee but my ports will not open on my router. I set up the port forwarding rules properly (and the Linux UFW ports) and disabled a whole bunch of stuff to make sure that wasn't it, but the ports will not open on portchecker. Do ISPs not allow these ports to open? I even tried alternative ports (8880, etc) and they wouldn't open either, as well as working with Copilot which had me run in circles for hours. At this point I feel like it would be easier to figure out Tailscale. 
I used this video which I think is the same thing but for Linux. It's by the same guy.
https://www.youtube.com/watch?v=1Ejobytuh5s
EDIT: Figured it out. Had to call ISP to get open ports.
I used this video which I think is the same thing but for Linux. It's by the same guy.
https://www.youtube.com/watch?v=1Ejobytuh5s
EDIT: Figured it out. Had to call ISP to get open ports.
I complain about Jellyfin a lot and have no idea what I'm doing.